|
CLT-70STC Power Supply with Screw Counter
No screws overlooked!
Screw Counter - No screws overlooked!
-
Compact design with built-in driver controller and
counter.
-
Screw counter for up to 99 screws, depending on the
work piece.
-
Displays the remaining screw count each time you
drive a screw.
-
Buzzer sounds when a screw is overlooked or when all
screws have been driven.
-
Screw counter is automatically reset and put into
the standby mode when all screws have been driven. The workpiece-set
signal input when the next workpiece is set breaks the standby mode.
(When the counter is in the standby mode, you cannot activate the
driver.)
-
Count timer prevents double counting of screws
tightened for conformation or for the second time.
Working efficiency enhanced by many functions
-
Controls external devices connected via 24V DC
terminal.
-
Prevents drivers from being activated by mistake.
You can activate a driver only while jig holds a workpiece.
-
Workpiece-set timer presets the time required for
setting and fixing a workpiece with jig.
-
Workpiece-reset timer presets the time required for
releasing a workpiece from jig when all screws have been driven.
-
Connectors for connection with multiple power supply
units for sequential operation of multiple drivers.
-
Disabling the counter function will allow you to fit
one of the Hios electric drivers, and to use this power supply for
the driver only. (The model in which combination is possible:
CL-2000, 3000, 4000, 6000, 6500, 7000, a-4500, 5000, 6500)
|
